With the stopper loosened, you can pull it out of the sink drain. This is where is gets gross, so make sure you have your rubber gloves on.
How to remove a garbage disposal stopper how to#
How to Clean the Stopper Mechanism and Pivot Rod If you want to clean the stopper mechanism or pivot rod, use a different sink. Warning: Do not turn the water on! With the stopper and pivot rod removed, water will flow out of the hole and all over the place.
How to remove a garbage disposal stopper free#
Make sure a basin is beneath the pipes so water doesn’t go everywhere when you remove the ball seal. Once the pivot rod is disconnected, you can free the pivot rod from the stopper by hand.If you cannot do it with your hands, use a pair of pliers. Disconnect the pivot rod from the clevis strap by squeezing the two end of the spring clip together and sliding it out. Get underneath the sink and look where your pivot rod is connected to the clevis strap.Then, raise the lift rod so the stopper closes all the way to form a tight seal.Next, place a bucket or some kind of container underneath the piping right beneath the sink.First, remove everything from underneath the sink so you have room to work.If you need to remove the sink stopper to clear a drain, wear gloves and be prepared for a messy and smelly experience. How to Remove the Sink Pop-Up StopperĬonsider putting on rubber gloves for this. The sluggishness could also be caused by hair and gunk trapped in the pipes and stopper mechanism. Still, it’s a good idea to regularly remove and clean the pop-up stopper. If the stopper still won’t sit correctly, try loosening the clevis screw and adjusting the lift rod. Raise or lower it hole by hole until you reach the perfect adjustment. All you’ll need to do is get under the sink and adjust the pivot rod by squeezing the spring clip and inserting the pivot rod into the next highest hole. If all you need to do is adjust your stopper because it is too tight or too loose, you don’t have to remove the stopper. If you cannot lift or twist it out, it may be attached to the pivot rod. If you cannot lift the stopper straight out, try giving it a slight twist to free it from the rod. Most sink stoppers are attached to a pivot rod. Knowing how to remove your pop-up stopper is also necessary when there is a major clog requiring clearing. For instance, a stopper mechanism that doesn’t open far enough may be contributing to your sluggish drain. When your stopper isn’t opening or closing properly, you will need to remove and inspect it. Gunk and smell (cleaning and maintenance).